Custom Scenery Exchange / Supports?

Kinda been looking if these exist but I'm afraid they don't...

Are there any b&m supports where the slanted pieces are leds steep? So you'd actually be able to realistically support a low to the ground helix..

And if they truly don't exist, is anyone willing to make these?

take a look at the NE Workbench 2013 by Louis!. It got supports and even more.

Yes it does! But I think what BelgianGuy is asking for is different. What we have right now are 3 different support "slopes": 1) Vertical, 2) Almost-Vertical, and 3) horizontal. I think BelgianGuy is asking if an intermediate angled version exists (i.e. a gentle slope), and to my knowledge it doesn't as of right now.

Exactly right seph, i think a very small gradient slope would be very welcome into the b&m support set...

Can you post an example screen? Sounds easy, just I can't picture what it would look like.

above is what we have, below is what Iwas looking for

HEY kumba, was the screen clear on what i meant? Basically it's supposed to be a support that Goes up one clearance... Instead of the very steep Ines we have now.

I can't speak for Kumba, but I guess he's as confused as I am... Maybe drawing it in paint will help? Enlarge a screenshot and paint away. Probably your best shot at explaining this

He just means a side beam that goes up 1/4 of the distance needed to built path under something. This support beam must therefore be less steep than the ones we have now. It would be nice to have one because this means you can also make corner supports for track low to the ground. I'm actually working on a custom support set that has these. However it's nowhere near finished, and I have exams now so it will take a while until they are.

Basically this, but then 1 lower and without it being shitty quality because it was made in 1 minute.

 

Exactly those recurious! That's what i meant

Yea, I don't know if they exist. I'm making a set for myself at least. I can share them when they are done. However as I said, I don't have time right now, so that might be a while.

Sorry, had no time for RCT the past few weeks (sister had a baby and NBA playoff DFS). I think I get it, just this means we'd need a support piece at another slope? That's tricky, but possible. No sense just making the connector, I would do a small set. Still fairly busy right now, but in the next few weeks I might be able to get something in the works.